Filename: Volvo Remove Install Overhaul-Turbo pdf
Language: English
File : PDF
Size: Mb
N – REMOVE/INSTALL/OVERHAUL – TURBO 1995 Volvo 850 1995 ENGINE PERFORMANCE Volvo – Removal, Overhaul & Installation 850 – Turbo INTRODUCTION Removal, overhaul, and installation procedures are covered in this article. If component removal and installation is primarily an unbolt and bolt-on procedure, only a torque specification may be furnished. FUEL SYSTEM WARNING: Always relieve fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components. FUEL SYSTEM PRESSURE RELEASE 1) Remove throttle pulley cover. Remove shield over valve on fuel rail. Connect Adapter (999 5484) to Fuel Drainage Unit (981 2270, 2273 and 2282). Connect adapter to valve on fuel rail, ensuring adapter is in locked position. Start fuel drainage unit. Unlock adapter. Raise and support vehicle. 2) Remove fuel filter valve cap located under vehicle. Connect Vent Hose (999 5480) to valve before fuel filter. System drain time is about 2 minutes. FUEL PUMP Removal & Installation 1) Fuel pump is located in fuel tank. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE. On station wagon models, lift luggage compartment floor cover and fold back carpet. On sedan models, tilt right rear seat forward. On all models, remove luggage compartment carpet and right wheel housing panel.
You can Download Volvo Remove Install Overhaul-Turbo pdf Below
If the information you are looking for less, you can use the sponsored links to get related information
Get the file Download here | PDF-HOME